Engraving
Multix Graver
Engraving solid
carbide end mill
Engraving solid carbide end mill
Engraving series available as standard with three shank diameters (D2): 3mm, 4mm and 6mm; with four opening angles (α): 15º, 36º, 60º and 90º; and with seven different tip diameters (D1) ranging from 0.1mm to 1mm.
HELIX Graver
Helical solid carbide end mill
for engraving and folding
Helical solid carbide end mill for engraving and folding
Solid carbide end mill with polished helical helix that facilitates the rapid chip ejection, getting the engraving surfaces clean and free of burrs, both in plastic as non-ferrous metals.
IS Graver
Coated solid carbide end mill
for engraving
Coated solid carbide end mill for engraving
Engraving end mill designed with an opening angle (α) of 35º or 60º and a very stable geometry.
All the references present a coating developed to engrave on all types of metals.
Glass Folder
Solid carbide end mill
for plastic folding
Solid carbide end mill for plastic folding
New end mill specially developed for folding plastic materials. It can also be used to bevel and engrave a wide variety of materials.
Micro Multix
Solid carbide single flute
end mill with upcut
Solid carbide single flute end mill with upcut
Micro single flute end mill, made of ultrafine grain solid carbide and designed with a very stable geometry optimized for universal use. Indicated for cutting and engraving operations.
Contact
- Av. Carlos III, 9, 41439 Cañada Rosal, Sevilla
- tecnico@grt-tools.com
Copyright © 2021 by GRT-Tools. All rights reserved. Designed by GRT-Tools