Aluminum, derived composites and other non-ferrous metals
ALU Endurance
Solid carbide single flute end mill
with upcut
Solid carbide single flute end mill with upcut
Micro grain solid carbide end mill specially designed for non-ferrous metal machining.
It features a very sharp cutting edge finished in an innovative tip geometry, specifically developed to facilitate immersion in the workpiece and improve the chip ejection in soft aluminum with a tendency to clog the tool during cutting.
ALU Endurance CC
Coated solid carbide end mill
with upcut
Coated solid carbide end mill with upcut
ALU Endurance series with multilayer coating that provides a low coefficient of friction and high resistance to wear. Our innovative coating allows the machining of any type of aluminum alloy, even in dry conditions, without the need for any type of lubrication.
ALU Endurance LDC
Coated solid carbide end mill
with upcut
Coated solid carbide end mill with upcut
Latest innovation for machining non-ferrous metals. Series designed to resist
abrasive effects as well as to prevent aluminum sticks to the cutting edge
during machining.
ALU-FOLDER
Solid carbide end mill
for 90º folding
Solid carbide end mill for 90º folding
Milling cutter made of integral solid carbide and fine balanced to allow
high feed machining with perfect finishes. Specially developed for grooving,
chamfering and folding.
ALU P-Folder
Welded plates end mill
for 92º and 135º folding
Welded plates end mill for 92º and 135º folding
Classic series with a steel body, on which two sharp solid carbide plates are brazed to give the highest cut quality.
It is developed for grooving, chamfering and folding.
PCD Master 1
PDC single flute
end mill
PDC single flute end mill
High density polycrystalline diamond end mill with high wear resistance. Its design is highly stable, allowing to obtain high cutting performance in the machining of different materials.
PCD HD Master
PCD end mill
with Z2 and Z3
PCD end mill with Z2 and Z3
New end mill designed in HD PCD for high feed cutting and grooving of highly abrasive materials.
V-Master
PCD end mill for 95º and
135º folding
PCD end mill for 95º and 135º folding
New HD PCD cutter developed for grooving, chamfering and high-feed folding of highly abrasive materials.
Saw blade Balanced-Cut
Ultra-fine
PCD saw
Ultra-fine PCD saw
New ultra-fine PCD saw blade optimized for universal use. It allows to obtain a high finishes quality, free of delamination both in the upper and lower part of the workpiece.
Multix Drill S3
Solid carbide drill
with Ø3 mm shank
Solid carbide drill with Ø3 mm shank
Solid carbide drill, designed with shank diameter (D2) of 3 mm and tip angle of 130º.
From drilling diameter (D1) of 3.1mm to 6mm, the point angle changes to 165º.
Multix Drill S6
Solid carbide drill
with Ø6 mm shank
Solid carbide drill with Ø6 mm shank
Solid carbide drill designed with a shank diameter (D2) of 6 mm and a tip angle of 130º ground on all four faces, which allows good self-centering when drilling. The helixs are micropolished to facilitate chip removal.
Contact
- Av. Carlos III, 9, 41439 Cañada Rosal, Sevilla
- tecnico@grt-tools.com
Copyright © 2021 by GRT-Tools. All rights reserved. Designed by GRT-Tools